Standard Features

HEATING COIL

Heating Coil, elliptically wound cold process of stretched reduced full body normalized ASTM A53/APIPSL schedule 80 or 160 pipe, and is structurally braced to minimize pipe wear and vibration, all completely sealed with ceramic blanket with stainless steel coil skin for total efficiency. You will save time and money on heat up time and fuel every time you use an Easy Kleen hot water cleaning systems.

GAS BURNERS

Natural aspirated ring cast burner with six oxygen port brass burner nozzles for lower emissions controlled by millivolt or 24 volt gas valves.

ELECTRICALLY HEATED HEATER

316 stainless steel heat exchanger coil, designed for continuous use, large 70 gallon (single coil models) and 120 gallon (dual coil models) heater storage tanks – allows for continuous recovery even when trigger gun (s) not in use, no open flame, can be installed in virtually any location, compact foot print, stand and explosion proof models, no venting required, heater exchanger coils do not require decalcification, require less KW than input direct-immersion type electrically heated models, low heat exchanger solution cut-off switch, adjustable temperature controller, pin- type Calrod heating elements with incoloy sleeves.

FRAME

Heavy gauge frame designs for specific applications all powder coated

*Warning California Proposition 65
Detectable amount of chemicals known to the State of California to cause cancer, birth defects or other reproductive harm may be found in pressure washing equipment, accessories and exhaust.