Refrigerated Compressed Air Dryer 266CFM Stainless Steel Plate

About this product

1. Stainless steel heat exchanger, high heat exchange with efficiency and energy-saving
2. HITACHI branded refrigerated compressor, R410 environmentally friendly gas
3. Dryer comes with hot gas by-pass valve
4. Condenser has a blue hydrophilic film with a strong resistance to rust
5. Delix or Schneider electrical components ensure the power supply
6. Every KL dryer goes through 24hours quality testing before shipment

Stainless steel plate heat exchange air dryer

Introduction

Plate heat exchange is a new type, highly efficient product which is made of corrugated metal pieces. The heat exchange is processed by the plate; compared with the conventional shell and tube type heat exchanger, under the same rate of the flow resistance and pumps power consumption, the heat transfer coefficient is much higher.

Technical Upgrade

★ Ambient Temperature ≤104℉

★ Max.Pre.: 232psi

★ Inlet Temperature ≤104℉

★ Dew Point: 35.6-41℉

★ Refrigerant: R-407c, R-134a

Attention

The installation site No-dust, No-Oil. Site formation, 31 in. away from the wall. According to the design of non-standard customized products.

BDL-60F Technical parameter table

Flow capacity	266CFM (Pressure P=101.33kPa、Temperature T=68℉ )
Design parameters	Inlet pressure	MAX232psi
	Inlet temperature	≤113℉
	Dew point	35.6-50℉
	Ambient temperature	＜100.4℉
Refrigeration system	Refrigerant compressor	5PS118
	Refrigerating capacity	3450W(evaporation temperature44.96℉, condensation temperature129.92℉
	Refrigerant type	R410A
	Refrigerant weight	2.42lb
	Condenser	plate fin type
	Evaporator	Stainless steel plate fin type
Power system	Voltage	AC1Φ 115-120V60Hz
	Power	1.65kW
	Refrigerant compressor	1.5HP
Connect	Compressed air	NPT 1-1/2”
Connect	Drainage	Φ8