67" Cold Laminator Fully-Auto Wide Format With heat-assisted and trimmers

This cold laminator can finish wide format graphics up to 63.8", and max laminating speed is 39.3"/min ( 12m/min)

This Laminator equipped with 4 trimmers with micro-adjust structure to ensure accurate cutting position.

TThe clip guard: Infrared ray of safety deflector device which makes sure the safety of the operator.

There are buttons and switches on front control panel or back of the machine for easy operation.

Product Detail:

1. Top and bottom rollers

The top and bottom rollers are one of the most important parts of the laminating machine which are made of silicon rubber. Silicon rubber has the characteristics of high temperature resistance, wear resistance, corrosion resistance and non-sticky.

2. Drawing axis, film axis, paper axis and finished product axis

The four mandrels are composed of aluminium rods, aluminum heads, bearings, rubber strips and other components. The outer diameter is controlled within 3 inches which facilitates the loading and unloading of conventional film products on the market, such as yellow film, laminating film and so on.

3. Pneumatica switch and cylinder

The pneumatic switch has upper, middle and lower 3 modes. In the case of air in the equipment, the top roller can be lifted up, the top roller can be lowered down, and the middle gear can temporarily lock the air inflow and output. The cylinder type of this equipment is SDA50-30, which makes the lifting height of the top roller more than 28mm (1.1").

4. Emergency stop switch

When the machine is in and emergency or dangerous state, the power supply can be cut off by the emergency switch and the equipment can be stopped to protect the safety of the person and equipment.

5. Cutters

The use of the cutting knife can make it possible to cut vertically and white edges at the same time in the process of laminating.

6.Tighten your grip

The tightening handle is mainly used to adjust the tightening force of four mandrels. Before leaving the factory, the four handles have been debugged accordingly. Users can use them directly. The tightening force is increased by twisting clockwise; the tightening force is reduced by twisting counterclockwise.

7. Simple control panel

Working Sketch Map

Applications:

This laminator with heat-assisted can be widely used for pre-masking vinyl graphicm mount prints on the substrate, over laminating inkjet prints and so on. The cold laminator is used for after printing. Widely applied for photographic, Ad. shop and copy shop to do lamination work, adding a protective layer on book cover, photographic, color pages, documents, charts, drawings, indoor advertising products, etc.

8. Operation Manual

Package:

The laminator comes with 2pcs of heating glass tube,

2 pcs is on the machine, 1pc is as a spare.

We send the spare 1pc of it just in case of any damage during the 

shipping. 
If the one on the machine damaged, please use the spare 1 pc replace it.